| layout | documentation |
|---|---|
| title | 507601 - ZWave |
{% include base.html %}
This describes the Z-Wave device 507601, manufactured by Merten with the thing type UID of merten_507601_00_000.
The device is in the category of Wall Switch, defining Any device attached to the wall that controls a binary status of something, for ex. a light switch.
The 507601 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
The flush-mounted CONNECT radio receiver with switch will be referred to below as flush-mounted receiver. The flush-mounted receiver can be used to switch loads on and off via radio (for information about permitted loads, see the technical data). When it receives the radio signal, the flush-mounted receiver switches the corresponding contact.CONNECT radio receiver, flush-mounted, 1-gang switch
Switching of ohmic, inductive or capacitive loads. To install in flush-mounted sockets or on a ceiling hook in the ceiling rose.
Triple click on the switch button
Triple click on the switch button
The following table summarises the channels available for the 507601 -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Switch | switch_binary | switch_binary | Switch | Switch |
Switch the power on and off.
The switch_binary channel is of type switch_binary and supports the Switch item and is in the Switch category.
The following table provides a summary of the 3 configuration parameters available in the 507601. Detailed information on each parameter can be found in the sections below.
| Param | Name | Description |
|---|---|---|
| 176 | Staircase timer byte 1 | |
| 177 | Staircase timer byte 2 | |
| 183 | Additional limit duration | (after brief interruption) Unsure what this does |
Values in the range 0 to 127 may be set.
The manufacturer defined default value is 0.
This parameter has the configuration ID config_176_1 and is of type INTEGER.
Values in the range 0 to 127 may be set.
The manufacturer defined default value is 0.
This parameter has the configuration ID config_177_1 and is of type INTEGER.
(after brief interruption) Unsure what this does
Values in the range 0 to 127 may be set.
The manufacturer defined default value is 30.
This parameter has the configuration ID config_183_1 and is of type INTEGER.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The 507601 supports 1 association group.
Association group 1 supports 5 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_SWITCH_BINARY_V1 | Linked to BASIC |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.